Panel clamp - used to connect panels together. We provide 2 per connection. They are made of galvanized pressed steel. One bolt passes through the center and provides an easy installation and removal should you wish to move the unit later. Put the nut on the inside of the enclosure. Thieves can't reach it to remove the nut and only a few dogs are smart enough to figure it out (Don't give them a wrench).

Clip Connections on Residential style kennel panels only. They are 'squeezed' tight to hold chain link to frame at the sides of the panels.

Tension Bands used on Medium and Commercial style kennel panels. A 5/16" x 1 1/4" bolt with a 1/2" hex nut hold the tension bar that stretches the chain link tight at the sides of each panel. They are stronger than clip connections. 5 per connection on 6' high panels, 4 per connection on 5' high panels and 3 per connection on 4' high panels. These are already installed when you receive your panels.

Aluminum caps - 2 per panel - These top off the ends of the panels. You install these by tapping them gently onto the upright ends after you receive your panels. They fit snugly; only a hard upward tap will remove them.